- I67 Surround Module Mono
- Mono to Surround Input Channel for the Integrator Mixing Frame
- 2 selectable Mono Inputs
- Switch-cash balanced Insert
- 100 mm Fader
- 5.1 Panoramic Section with Divergence and LFE-Regler
- PFL and Solo in Place
- Channel On-Switch
- Stereo-Cue with Level and Pan, 2 Aux Sends
- all Sends with Pre/Post Switch
- Cue-Send as a Monitor Path on Input 2
- Levelmeter with 4 LED's
- Switch-cash balanced Insert
- The I67 Surround Module the mono version. It is suitable for installation in the INTEGRATOR Main Frames or extension Frames with full 5.1 pan capabilities. It can be used with other INTEGRATOR modules to create a fully functional, stereo and/or 5.1 custom mixing, recording or mastering console. Because the INTEGRATOR system is totally modular and has a vast range of module types, the size and scope of almost any conceivable system is limitless. The fact that it is also compatible with the V700 system greatly increases its possibilities.
Input
The I67 mono unit has two electronically balanced mono inputs. The switch INP2 selects the second input. The chosen input can be regulated by the GAIN with a range of ± 20 dB. The regulated signal is supplied to the insert point.
Insert
Processing and any other treatment devices can be inserted into the audio chain. The insert point is implemented electronically balanced. The insert output always leads signal. The switch INS, switches the insert into the audio chain.
Fader, PFL and Solo
The input of the fader can be monitored directly without affecting the audio chain. The solo logic works as a solo in Place and mutes un-selected channels. With the SAFE switch the channel can be taken off of the solo rail. A 100-mm fader regulates the output level. The fader controls the signal level on the pan pot and the channel output amplifier. As long as the CH-ON is not pressed, the channel is muted. The mute does not concern the cue send in pre mode, the level meter and the PFL system but the aux sends in post and pre mode as well.
The LCR-Pan regulates the 3 front channels. The Divergence knob determines the Surround channels, LS and RS and front-side approach. The front Surround Pan regulates the balance between front channels and surround channels with a center pad of 3 dB. In the extreme positions the Surround channels or the front channels are muted, and the LFE pot controls the LFE channel.
Sends
Two mono aux sends and a stereo cue exist. Both aux sends are post fader by default and can be switched pre fader individually. The stereo Cue is implemented with a level and a pan pot and can be switched pre/post fader. However, for the Cue the PRE tap is located before the channel mute and the solo circuit. If the cue send is used as the tape sends for recording, solo and channel on may be used without affecting the recording. The switch INP2 puts the cue send with priority on the second module input. If the second input is used as a tape return, the cue send can be used as monitor path while the main input is used as the record path.
A peak meter with 4 LED's indicates the input.
