- I63 5.1 Input Module
- Surround Input Module for the 5.1 Version of the Integrator Mixing Frame
- 5.1 Line Input
- 100 mm Fader
- LFE-Pegel ± 10 dB Range
- PFL and Solo in Place
- Channel On-Switch
- Stereo-Cue with Level and Pan
- Levelmeter with 4 LED's
- The I63 5.1 input modulel is suitable for installation in the INTEGRATOR Main Frames or extension Frames with full 5.1 pan capabilities. It can be used with other INTEGRATOR modules to create a fully functional, stereo and/or 5.1 custom mixing, recording or mastering console. Because the INTEGRATOR system is totally modular and has a vast range of module types, the size and scope of almost any conceivable system is limitless. The fact that it is also compatible with the V700 system greatly increases its possibilities.
The I63 5.1 input module is used a six channel line input for the use with 5.1 sources. Its gain is fixed to 0 dB and its input use the six available connector on each frame slot. The LFE pot with a range of ± 10 dB serves for the adaption of the level of the LFE channel..
Fader, PFL and Solo
The input of the fader can be monitored directly without affecting the audio chain. The solo logic works as a solo in Place and mutes un-selected channels. With the SAFE switch the channel can be taken off of the solo rail. A 100-mm fader regulates the output level. The fader controls the signal level on the pan pot and the channel output amplifier. As long as the CH-ON is not pressed, the channel is muted. The mute does not concern the cue send in pre mode, the level meter and the PFL system but the aux sends in post and pre mode as well.
A stereo cue send is driven from the input of the module. It is implemented with a level and a pan control. A separate pre fader downmix matrix generates a stereo signal for the cue send.
A peak meter with 4 LED's indicates the input and displays the channel with the highest level.If the I63 5.1 input module is used with the I52 master section, only the front left and front right channels can be used.