| Technical Specifications |
STEREO MASTERING LIMITER with DELAY U795 |
| Size |
Stereo in V700-Module 1N |
|
| Input |
|
| Type |
balanced, floating, torodial Transformer, or balanced, grounded |
| nominal Level |
+ 6 dBu |
| maximum Level 1) |
ƒ ³ 40 Hz ³ + 30 dBu |
| Input Impedance |
ƒ 40 Hz - 15kHz ³ 5 kW |
| CMRR |
ƒ 40 Hz - 15 kHz ³ 60 dB according to IRT |
|
| Output |
|
| Type |
balanced, floating, torodial Transformer, or balanced, grounded |
| nominal Level |
+ 6 dBu |
| maximum Level1) |
ƒ ³ 40 Hz, kges 1 % ³ + 30 dBu |
| Source Impedance |
ƒ 40 Hz - 15 kHz £ 40 W |
| Load Resistance |
³ 300 W |
| CMRR |
ƒ £ 15 kHz ³ 40 dB according to IEC |
| CMRR |
ƒ £ 15 kHz ³ 60 dB according to IRT |
|
| Gain 2) |
all Controls at 0 dB Position 1 kHz 0 dB ± 0.5 dB |
|
| Frequency Response 2) |
ƒ 20 Hz - 20 kHz ± 0.25 dB |
| Phase Response 2) |
- Input/Output ƒ 40 Hz-15 kHz £ +5/-20°
- with Standard Values for RF & LF Filters
|
|
| THD 3) |
£ +26 dBu, ƒ ³ 40 Hz - 15 kHz, kges £ 0.1 % |
|
| Crosstalk |
L-R, ƒ 40 Hz - 15 kHz £ 70 dB |
|
| Dynamic Range 2) |
22Hz-22kHz RMS ³ 122 dB |
| Noise Level 2) |
22Hz-22kHz RMS £-92 dBu |
|
| Size |
V700-Module - StandardSize |
| Frame |
fits into Standard Frames |
|
| Control Elements |
Stepper Pots - 21 Steps |
| Delay |
analog Delay Line with > 35 µs Delay Time, linear in the Frequency Range up to >20 kHz
inserted by Push Buttom DELAY |
| Threshold |
-6 dBr ... + 20 dBr - 0 dBr = + 6 dBu |
| Attack |
0.01 ms ... 5ms
without Delay
- 10 µs minimal with Delay |
| Release |
20 ms ... 3 s |
| Release LF Ratio |
Release Time Modulation
depending on the Low Frquency Components |
| Release LF max |
Limits the max possible Release Time caused by Modulation |
| Release Peak Rat |
Release Time Modulation
depends on the Peak Signals |
| Release Peak max |
Limits the mn. Releasetime caused by Modulation
up to 1 sec |
| Ratio |
> 50 : 1 |
| Input Gain |
Controls the Gain pre the Limiter
0 dB ± 0.2 dB, Range +/- 10 dB |
| Output Gain |
Controls the Gain post the Limiter
0 dB ± 0.2 dB, Range +/- 10 dB |
| HUE |
Side Chain Filter to control the frequency response under Regulation, Control Range +/- 4 dB,
0 dB kalibriert, Frequency select with Stepper Switch in 6 Steps from 1.5 kHz to 8.2 kHz |
| Display |
- Gain-Reduction with 10 Led's, 1 to 10 dB
|
|
- 1)
- Depending on the setting of the control, gain or attenuation is possible. The value is valid for the higher level at the input or output.
|
|
|
|
|
- 3)
- The settings and the signal frequency can affect the THD values. The values refer to inactive regulation.
|
|
| Index |
Home V700 Home |