CLOSE
Technical Specifications SURROUND-MONITOR CONTROLLER W761
Size V700-Module 1N

Input 4-Channel
Type balanced
nominal Level + 6 dBu
maximum Level1) ƒ ³ 40 Hz ³ + 30 dBu
Input Impedance ƒ 40 Hz - 15kHz ³ 25 kW
CMRR ƒ 40 Hz £ 15 kHz ³ 60 dB according to IRT

Output 4-Channel
Type balanced
nominal Level + 6 dBu
maximum Level1) ƒ ³ 40 Hz, kges 1 % ³ + 26 dBu
Source Impedance ƒ 40 Hz - 15 kHz £ 60 W
Load Resistance ³ 600 W
CMRR ƒ £ 15 kHz ³ 40 dB according to IEC
CMRR ƒ £ 15 kHz ³ 60 dB according to IRT

Gain 2) all Controls at 0 dB Position 1 kHz 0 dB ± 0.5 dB

Frequency Response ƒ 20 Hz - 20 kHz ± 0.5 dB
Phase Response
Input/Output ƒ 40 Hz - 15 kHz £ +5°/-20°
with Standard Values for RF & LF Filters

THD £ +26 dBu, ƒ ³ 40 Hz - 15 kHz, kges £ 0.1 %

Dynamic Range 22Hz-22kHz RMS ³ 120 dB
Noise Level 22Hz-22kHz RMS £-90 dBu

Crosstalk arbitrary Channels ƒ 40 Hz - 15 kHz £ -70 dB

Size V700 Standard Module Size, standard Depth
Frame
for Console Frames and Custom Frames only

Control Elements

Stepper Switch / Stepper Pots

Volume Control
21 Steps from Off to 92 dB-SPL
Gain at 92 dB-SPL 0 dB ± 0.25 dB
without Matrix Stages or Direction Control active
Direction Control
21 Steps from 'left only' to 'right only'
calibrated in % of half of the stereo base width
0 Position ± 0.25 dB

Headphone
Headphone Output with Level Offset Control for volume adapting,
suited for Headphones 4W to 2kW
Headphone Feed from Stereo Matrix
PFL
activated by Push Button or by Remote Control Voltage, isolated by Opto Coupler 9 to 30 V
additional, balanced Input
Level Control
DIM
Control Range from 10 to 30 dB
activated by Push Button or by Remote Control Voltage, isolated by Opto Coupler

Decoder passive Relay Switchin of external Decoder
Monomatrix internal Selection 3 dB or 6 dB Mode
Left-Right Reversal

by Push Button L<>R

Phase Reversal in right Channel by Push Button ØR
Muting alle Ausgänge by Push Button CUT
2. Monitor System Stereo, passiv selection by Push Button ALT


1) Depending on the setting of the control, gain or attenuation is possible. The value is valid for the higher level at the input or output.

2) Refers to linear adjustment of all parameters

Index Home V700 Home